ROOF COATINGSilicone & Acrylic

Working in Sherman Oaks

If you own property in Sherman Oaks, the local conditions decide what your roof needs: the valley holds heat, and the daily swing works every seam and lap. 14 miles northwest means a free inspection costs you nothing but an hour.

We work the same streets in Van Nuys, Valley Glen and Encino, so crews know the area and its roofs.

• Permits and inspections run through the local building department, and we pull them rather than leaving it to you.
• Gutters are pulled and refitted properly instead of being crushed by a ladder.
• Tile is sorted and reused where it is sound, which keeps the roof looking original.
• Magnet sweeps run morning and evening, which matters on a street with kids and bare feet.
• Chimney and wall flashings are replaced, not painted over with sealant.

Book in the dry months and the whole job happens on dry decking. Everything starts with a free inspection and a written number for your Sherman Oaks property.

Standards we hold on every Sherman Oaks job

You get the manufacturer warranty on the materials and ours on the workmanship, both in writing.

• Driveways get swept and gutters cleared as part of the job, not as an extra.
• Edges are fastened to spec because that is where uplift starts.
• We do not ask for large deposits before material is delivered.
• We check the attic as well as the roof; half of what we find shows from underneath.

Conditions we plan for in Sherman Oaks

We quote Sherman Oaks roofs off what the roof is actually doing, and summer heat bakes the field of the roof while the nights pull it back cold. Being 14 miles northwest of Sherman Oaks, we can be on the roof before the next rain band arrives.

Van Nuys, Valley Glen and Encino are on the same route, which keeps follow-ups easy.

• Chimney and wall flashings are replaced, not painted over with sealant.
• Gutters are pulled and refitted where they block a proper drip edge.
• Skylights are re-flashed as part of the job rather than quoted as an extra later.
• Skylights are flashed new rather than reused, because that is where the next leak starts.
• Solar panels get detached and reset on a schedule that matches the roofing crew.

Book in the dry months and the whole job happens on dry decking. Expect photos, a measured scope and a number you can compare against anyone else.

Our habits on site

We show you the soft spots before they are covered, not after.

• Payment is tied to progress, not demanded up front.
• Rake and eave metal is new on every job; reusing bent metal is false economy.
• We photograph every slope and penetration so you see what we see before deciding anything.
• Ridge venting goes in where the roof line allows it, with proper intake at the eaves.

CALL (818) 275-0921 GET A FREE INSPECTION