Licensed | Insured | Family Owned & Operated
(818) 275-0921 CALL NOW · OPEN 7 DAYS
Fallbrook Torch Down Roofing
GET A ROOF QUOTE TODAY
RESIDENTIAL • COMMERCIAL • ALL ROOF TYPES
- LICENSED
& INSURED - FAST
RESPONSE - EXPERIENCED
ROOFERS - QUALITY
WORKMANSHIP
BUILT FORSouthern California
Professional torch down roofing — stronger roofs for a safer tomorrow
Our 2-ply Polyfresko torch down roofing systems provide long-lasting, waterproof protection for flat and low-slope roofs. Designed for durability and performance, this system is ideal for residential, multi-family, HOA and commercial buildings across Fallbrook, Los Angeles and Southern California. Waterproof protection, durable and long lasting, UV and heat resistant, ideal for flat roofs, professional installation.
IDEAL FOR MULTIPLE PROPERTY TYPES
RESIDENTIAL HOMES
APARTMENTS & HOAs
COMMERCIAL BUILDINGS
LOW-SLOPE ROOFS
BEFORE & AFTER
FALLBROOK, CA
Torch Down Roofing
Two Plies, Welded Seams, No Guesswork.
Torch down roofing in Fallbrook is modified bitumen, installed in two plies and heat-welded as it goes down: a base sheet torched to the prepared deck or cover board, then a white Polyfresko cap sheet over it. The seams fuse instead of relying on adhesive, which is why the system holds up on flat and low-slope roofs that see standing water.
All American Roof Repair & Commercial Roofing installs and repairs torch down on houses with flat sections, apartment buildings, HOA property, offices and light industrial across Fallbrook, Tujunga, Shadow Hills, Lake View Terrace and the northeast San Fernando Valley.
Why Flat Roofs in Fallbrook Fail
Fallbrook sits in a bowl at the foot of the Verdugo and San Gabriel Mountains and it bakes. A dark flat roof here runs far hotter than the air, the daily swing works every lap, and the fall winds drive grit across the surface. Then the rain arrives in short, heavy bursts and finds whatever the summer loosened: a split lap, a lifted edge, a drain that has not been cleared since the last storm.
How We Install It
Tear-off and deck check
The old roof comes off and any soft decking is replaced before a new sheet touches it. You see the bad bays before they are covered.
Insulation or cover board
Where the building wants R-value, polyiso goes down; otherwise a cover board gives the torch a sound, even surface.
Base sheet
The modified bitumen base ply is torched and rolled so the whole sheet bonds, not just the edges.
Polyfresko cap sheet
The white cap ply goes over it, seams welded and probed. White means the roof reflects heat instead of storing it.
Flashings and drains
Curbs, pipes, parapets, edge metal and drains are detailed last, because that is where flat roofs actually leak.
Torch Down vs the Alternatives
- Against a patch. Patching buys months. A two-ply system is a roof, with a manufacturer warranty behind it.
- Against TPO. Both work on flat roofs. Torch down suits smaller, cut-up roofs and buildings with lots of penetrations; TPO suits wide open spans.
- Against a coating. A coating renews a sound roof. If the deck or insulation is wet, torch down replaces it instead of sealing the problem in.
- Against built-up. No kettle, no gravel, and a white surface rather than black asphalt cooking all afternoon.
Straight talk: torch down is hot work. We carry the permits and insurance for it, run a fire watch and keep extinguishers on the roof. Where open flame is not appropriate — a wood deck in poor condition, an occupied building with tight access — we quote a cold-applied or coating system instead and say why.
What We Roof in Fallbrook
If the roof is flat or low-slope, torch down is on the table:
-
Homes with Flat Sections
Additions, garages and mid-century flat roofs where shingles were never the answer.
-
Apartments & HOAs
Staged section by section so tenants stay put and the lot stays usable.
-
Commercial Buildings
Offices, retail and light industrial, scheduled around your hours.
-
Low-Slope Roofs
Shallow pitches where water moves slowly and details decide everything.
Before and After
The same roof, cracked and ponding, then two plies down with a white cap sheet.
Warranty and Lifespan
Installed to spec, a two-ply torch down roof runs twenty years and up, and the manufacturer warranty is written for 10, 20 or 25 years depending on the system we specify. The paperwork is registered in your name, not left in a folder. We check the roof after the first rainy season so small things stay small.
Repairs and Maintenance
Most calls start with a leak over one room. We trace it to the source — a split lap, a failed pipe flashing, a drain that never cleared — repair it and photograph what we found. Two things keep a flat roof going: clear the drains before the rains, and have the flashings looked at once a year.
Serving Fallbrook and the Foothills
We install and repair torch down throughout Fallbrook, Tujunga, Shadow Hills, Lake View Terrace, La Crescenta, Sylmar and the rest of the northeast San Fernando Valley. Flat roof work is dry-weather work, so the calendar tightens once the rain starts — call early.
We’ll measure the roof, check the deck, drains and flashings, and tell you whether torch down is the right system.
TORCH DOWN ROOFING FALLBROOK, CA
THE COMPLETE GUIDE TO
TORCH DOWN ROOFING IN FALLBROOK
Most Fallbrook buildings with a flat section end up on modified bitumen, and the install decides whether it lasts five years or twenty. Up against the hills the wind gets at the edges first, so the perimeter metal and the first course decide how long the roof holds.
When we recommend something else
If the insulation is wet, no membrane fixes that - it comes off first, whatever it costs.
What it costs in Fallbrook
Price follows square footage, how many layers come off, how much decking needs replacing and how many penetrations the roof carries.
A cut-up roof with ten curbs costs more per square than an open one, because the detailing is the work.
What you can expect from it
Installed to spec, a two-ply torch down roof runs twenty years and up. The manufacturer warranty is written for 10, 20 or 25 years depending on the system, and we register the paperwork in your name.
Why Fallbrook roofs wear the way they do
Nobody roofs Fallbrook the way they roof a tract in the desert, and gusts funnel down the canyons and lift anything not fastened right. At about 86 miles southeast, Fallbrook is an easy run for us, inspection or emergency.
The roofs in Bonsall, Vista and Temecula are built much the same way, and they fail the same way.
- We photograph every penetration before and after, so the file shows the work.
- Permits and inspections run through the local building department, and we pull them rather than leaving it to you.
- Solar gets detached and reset by a licensed crew, not improvised around.
- Skylights are flashed new rather than reused, because that is where the next leak starts.
- Satellite dishes and A/C line sets are re-flashed, not just set back down.
A roof opened in October is a different job from one opened in January. We will tell you if the Fallbrook roof has years left in it rather than sell you a new one.
What goes on your Fallbrook roof
- Roof deck, repaired where it is soft
- Insulation or cover board, depending on what the building needs
- Modified bitumen base sheet, torched and rolled so the whole sheet bonds
- White Polyfresko cap sheet, seams welded and probed
- Edge metal, curb and pipe flashings detailed last
Our process in Fallbrook
- Free inspection with photos of every penetration and drain
- Written scope and price before anything is booked
- Tear-off and deck repair, with bad bays shown to you
- Two plies down, welds probed as the crew goes
- Flashings, drains and edge metal detailed
- Daily clean-up and a final walk with you on the roof
Why we specify two plies in Fallbrook
The practical reasons it keeps getting specified here:
- It handles ponding better than a single-layer repair ever will
- Heat-welded seams fuse the plies instead of relying on adhesive
- Repairs weld into the existing sheet, so a fix becomes part of the roof
- It suits cut-up roofs with curbs, pipes and skylights
- Two plies mean a second line of defence over the whole roof, not just the patches
Serving Fallbrook and nearby
We install and repair torch down roofs throughout Fallbrook and the surrounding San Diego County communities, including Bonsall, Vista and Temecula.
Get a number in writing
The estimate is free. Call (818) 275-0921 and we will measure your Fallbrook roof, check the deck, laps and drains, and tell you plainly whether coating is the right call.
Our habits on site
Soft decking gets replaced, not covered - we quote a sheet count and show you the bad bays.
- We do not ask for large deposits before material is delivered.
- Drone shots cover the steep sections, and the rest is checked on foot.
- Synthetic underlayment goes down over the whole deck, not just the valleys.
- Nothing is left on the lawn overnight, and the dumpster goes when the job ends.
After the job in Fallbrook
Price follows the roof, not a rate card: access, pitch, material, how many layers come off and what the deck looks like underneath. We measure in person, show you photos and put the number in writing before anything is booked.
Cheap work shows up at the details: a flashing sealed instead of replaced, a vent reused because it was quicker, decking covered because nobody wanted the conversation. Those are the roofs we get called back to in two winters.
What goes wrong when it is done cheap
When the crew leaves, the debris leaves with them: magnet passes morning and evening, gutters cleared, driveway swept. You get photos of the finished work and the warranty paperwork registered in your name.
FREQUENTLY ASKED
QUESTIONS
Find answers to common questions about torch down roofing in Fallbrook.
CLEAR ANSWERS. LOCAL EXPERTISE.
FALLBROOK, CA TORCH DOWN ROOFING
Do you give free estimates in Fallbrook?
Yes. The inspection and the written estimate are free, including a second opinion if you already have a quote in hand. We photograph what we find and walk you through it.
How much does a new roof cost in Fallbrook?
Cost depends on the size and pitch of the roof, the material you choose, how many layers come off and what the deck looks like underneath. We inspect the Fallbrook property, measure it and put a detailed number in writing before anything is booked.
Do you pull permits in Fallbrook?
We do. Permits and inspections go through the local building department and we handle the paperwork rather than leaving it to you.
What is the 2-ply Polyfresko system?
A modified bitumen base sheet torched to the deck or cover board, with a white Polyfresko cap sheet over it. The white surface reflects heat instead of holding it.
Is the torch safe around my Fallbrook building?
We carry the permits and insurance for hot work, run a fire watch and keep extinguishers on the roof. Where open flame is not appropriate we quote a cold-applied or coating system instead.
What happens to the old roof and the mess?
Tear-off debris leaves the same day. Driveways are swept, gutters cleared and a magnet pass runs morning and evening, which matters on a street with kids and pets.
Is torch down right for a flat roof in Fallbrook?
For most flat and low-slope roofs in Fallbrook, yes. Two plies of modified bitumen with heat-welded seams handle ponding and UV far better than patching.
How long does a torch down roof last?
Installed to spec, twenty years and up, with a manufacturer warranty of 10, 20 or 25 years depending on the system.
Fallbrook Torch Down Roofing — and the five closest cities
If you are on the edge of Fallbrook, these are the neighbours we also serve:
- Bonsall Torch Down Roofing 6 mi
- Vista Torch Down Roofing 12 mi
- Oceanside Torch Down Roofing 15 mi
- Carlsbad Torch Down Roofing 16 mi
- Valley Center Torch Down Roofing 17 mi
We cover Bonsall, Vista, Oceanside, Carlsbad and Valley Center from the same yard as Fallbrook. One call covers any of them.
